Phase Lead Controller Design and Digital Implementation and PID CONTROLLER

ASSIGNMENT – Phase Lead Controller Design & Digital Implementation and PID CONTROLLER

 

The arm of a hydraulic robot is controlled as shown in the block diagram below:

 

The arm dynamics are represented by:

 

Dynamic specification for the arm requires:

 

  • Percentage overshoot for a step input < 20%
  • Rise time < 1.2 seconds
  • Velocity constant, Kv ³ 10

 

Part 1: Phase Lead Controller Design  30%

  1. Design a suitable phase-lead controller. You should explain in detail how your design has been developed. Your solution should include Bode plots constructed both manually and using an appropriate package such as MATLAB or Scilab.            (20%)
  2. Using the design rules in the Control Engineering Data Sheets, obtain the TF of the “equivalent” 2nd order TF (including controller). (5%)
  3. Compare the unit step responses of the equivalent 2nd order TF and the actual closed loop system, and comment on the accuracy of the equivalent. (5%)

 

Part 2: Digital Controller Implementation 35%

  1. Using the phase lead controller transfer function obtained above as a prototype, design a digital controller using Bilinear Transform or any other method of your choice (10%)
  2. Select a suitable sampling increment, T, given the following constraints:
  • the minimum value for T is, T= 1mS
  • the value of T should be as large as possible, but must provide a unit step response that is within a 5% error band around the unit step response obtained from the ‘ideal’ closed loop system designed in Part 1. (15%)
  1. Compare the performance of the digital controlled system with the analogue controlled system obtained in Part 1 (this should include consideration of both time domain and frequency domain responses). (10%)

 

Part 3: PID Controller 35% 

With reference to the following journal paper:

 

  1. H. Heong, G. Chong and L. Yun, (2005), PID Control System Analysis, Design, and Technology, IEEE Trans. On Control Systems Technology, vol 513, No. 4, pp. 559‐576.

 

Discuss:

  1. Reasons for the widespread use of PID control.-i.e. Why so popular
  2. The range of applications that have adopted PID as the preferred control method.
  3. The range of methods used to obtain suitable PID parameter settings. (i.e. tune)
  4. The particular control problems caused by process dead‐time or transport delay.
  5. The cause and effect of “integrator wind‐up”, and methods that have been developed to overcome this problem

 

What We Offer:
• On-time delivery guarantee
• PhD-level professionals
• Automatic plagiarism check
• 100% money-back guarantee
• 100% Privacy and Confidentiality
• High Quality custom-written papers

find the cost of your paper

Calculate the maximum achievable bridge out-of-balance voltage for an applied torque T of 103 N m given the following

Four strain gauges, with specification given below, are available to measure the torque on a cylindrical shaft 4 cm in diameter connecting a motor and load. (a) Draw clearly labelled….

Find the gain and phase characteristics of the maintaining amplifier.

A solid-state capacitive humidity sensor has a capacitance given by: C = 1.7 RH + 365pF where RH is the percentage relative humidity. The sensor has an associated parallel resistance….

calculate the mean velocity of the gas at maximum flow rate

A pitot tube is used to measure the mean velocity of high pressure gas in a 0.15 m diameter pipe. At maximum flow rate the mean pitot differential pressure is….